CX_SY_MESSAGE_IN_PLUGIN_MODE

Hello experts,

I am writing some application for win CE devices in .net. It should communicate with SAP through BSP (I have no rights to configure wdsl). There is one page in BSP Application, with the parameter XML. In the event OnRequest I call FM L_TO_CONFIRM. From time to time it raises exception CX_SY_MESSAGE_IN_PLUGIN_MODE. I catch this exception in the try catch block to figure out what's wrong. I then pass some response outside the try endtry block to the parameter XML, but then after exiting the method of the OnRequest event it runs empty method if_abap_runtime~get_runtime by kernel module ab_kmGetRuntimeHR and the parameter XML is send to the device empty. I'd like to send the error message back.

Please help.

Thanks in advance.

The code is something like that:

try.
 call function 'L_TO_CONFIRM'  exporting i_lgnum = lgnum                  i_tanum = tanum                  i_qname = uname  tables      t_ltap_conf = tltap  exceptions ....
.

catch cx_sy_message_in_plugin_mode into oref.
  clear message.  select single text from t100   into (message)  where sprsl = sy-langu      and arbgb = oref->msgid      and msgnr = oref->msgno.

if sy-subrc <> 0.  message = 'Unknown error'.
endif.

endtry.

if not message is initial.
  concatenate '<resp><state code="err" num="500">' message '</state>' body '</resp>' into xml.  exit.
endif.

if sy-subrc <> 0.

.......

The layout is:

<%@page language="abap"%>

<?xml version="1.0"?>

<%=xml%>